How To Use - ANLAN YD760 Manual De Usuario

※If the eyes and the area around the eyes become warm
after use, the eyes and eyes may temporarily become red,
but they will become lighter over time. If symptoms do not
improve, consult a specialist.
※Since this product gently presses the area around the
eyes, the eyes may become blurred, burning, or
uncomfortable after use, but this is not a malfunction. You
will be back in a few minutes. If your eye discomfort does
not recover over time, please consult the doctor.

How to Use

Operation of button [Power on/off /Mode/Music play ]:
Long press the power button
then the power is turned on. The display lamp displays
the integrated mode, with ringing the integrated mode
tone and playing the built-in music, and starts the
integrated mode.
When the power button
is switched（ Integrated mode → eye beauty mode →
sleep mode → eye protection mode.)
After turning on the power, start from integrated mode
every time.
Briefly press the power button
music broadcast will be turned on / off.
Press and hold the power button
seconds, and the power will turn off.
※The working time for each mode is 10 minutes. The power
will be turned off automatically after 10 minutes, so please
restart it if you want to continue using it.
for more than 2 seconds,
is pressed briefly, the mode
twice and the built-in
for more than 2
Eye care mode:
Integrated mode
Beautiful eyes mode
Sleep mode
Eye care mode
※Only the beauty mode is equipped with the thermal care
function.
※The warm part of thermal care (beauty mode) only works
for the lower eyelids. (The temperature gradually rises and
the preheating time is about 30 seconds.)
※Temperature may change depending on the usage
environment. (40 ± 2 degrees)
EMS Mode(ON/Off)/EMS Level:
Press and hold the EMS button
longer to turn on EMS mode and start from level 1.
Short press the EMS button
(Highest level 5)
Short press the EMS button
Press and hold the EMS button
longer to turn off EMS mode.
※The skin around the eyes is so dry that you feel a tingling
sensation, so apply a thin layer of gel to the eyes and adjust
to level 1 before use. Do not increase the EMS level
(strength) for the first time use. After using it many times
and waiting for the skin to adapt to the current sensation of
EMS, You can adjust the strength and try using it.
※If you feel any abnormality on your skin, please discontinue
use immediately.
for 2 seconds or
to go up the level.
twice to exit the level.
for 2 seconds or