Kidomo F02 Manual Del Usuario página 5

Insert the battery into the drone (3.7V 650mAh Li-Po battery included)
RECHARGING DRONE BATTERY
First, take the battery out of the drone and connect one end
of the USB charging cable to the USB interface of the
computer (or USB power adapter) and the other end to the
battery charging jack. The USB light will be on when charging
and off when fully charged, and the charging time will be
about 40 minutes.
NOTE: Only use the provided charging cable. Do
not use the provided charging cable to charge
other products.
READY TO FLY
HOW TO SET THE FREQUENCY
Step1: Turn on the power of the fuselage and place the drone on a level surface.
Step2: Turn on the power switch of the remote control.
Step3: The two LED lights at the front of the drone will flash. Push the left joystick
of the remote control to its highest point, then pull it to its lowest point. The
controller will "beep", indicating that frequency setting is complete. After
completion, the LED light at the front of the drone will be steadily lit.
Step1
3
Step2 Step3