Publicidad
Idiomas disponibles
Idiomas disponibles
When using the remote control for the first time, install two no. 7 batteries for using.
The remote control can be used to set the same function as on the appliance. Please note that some
functions can only be controlled with the remote control which is listed below:
Auto mode
Negative ion
function
LED display light
Sleep mode
function is active, "H" will be shown on the display and after 5 seconds the PM2.5 value will be shown
in alternation. Press the button again to deactivate the turbo function.
deactivated.
will be lit. When pressing this button again, all indicating lights will light up again.
During sleep mode, all sounds and lights are turned off except from the ON/OFF button.
Only the ON/OFF button and the SLEEP button can be operated.
You can use the timer function to turn off the appliance after 1-24 hours automatically. Press
the TIMER button to set the time by 1 hour with each pressing. When the timer is activated, the
hours will be shown on the display for 5 seconds before the PM2.5 value reappears. When the timer
countdown is over, the appliance turns itself off. Alternatively, you can cancel the timer by pressing
and holding the timer button for 3 seconds.
Please press this button to activate the turbo function. When the
When pressing this button the negative ion function can be activated and
If the LED display light is turned off, only the ON/OFF button
23
Turbo function
High-Speed "H"
Child lock function
Timer
Performance levels
Publicidad
