Publicidad
Idiomas disponibles
Idiomas disponibles
• Please make sure the electrical system of your motorcycle
functions properly before installation. Please follow
steps below:
1. Connect motorcycle red cable to the positive terminal,
black cable to the negative terminal, and then start
the motorcycle;
2. Connect a multimeter red cable to positive, black cable
to negative. The multimeter will indicate the battery
open circuit voltage;
3. Disconnect positive battery terminal from the motorcycle.
The multimeter will indicate the motorcycle output char-
ging voltage. The charging voltage should be between
14V and 15V. The battery will not be fully charged if the
charging voltage is less than 14V, and the battery will be
overcharged if the charging voltage is above 15V. Either
circumstance will damage the battery. This test should
be repeated at 2,000 and 5,000 RPM;
4. Switch off the motorcycle and take out the key.
Connect the multimeter (milliamperes function)
between battery and motorcycle cable (either posi-
tive or negative terminal) in series. Then check the
motorcycle power consumption in milliamps to make
sure the drain current is less than 1mA when motor-
cycle is switched off;
5. If the motorcycle passes the above tests, BS BATTERY
lithium battery can be installed on the motorcycle.
• Remove the old battery from the motorcycle.
• Compare the new battery with the old one, and use the
attached plastic spacers to adjust the dimensions if
necessary, to make sure new battery can be installed
firmly in the battery box.
8
• The diagram on the right side will show you how to extend
the dimension of BSLi-12 to replace original lead acid
battery BTX30L-BS.
• By using the plastic spacers, the battery can be installed
firmly, and meanwhile it has better vibration resistance
and better heat dissipation.
• The rubber covers on the positive terminal care for pre-
venting battery's short circuit during the transportation.
Please remove them before installation.
• Any questions about the installation or operation, please
contact the dealer directly for help.
Terminal cover
Terminal screw
Adapter
Battery
Adhesive pad
USAGE
• When use this battery to start a vehicle, each starting
time should not exceed 5 seconds, with an interval of not
less than 5 seconds between 2 times starting. Battery
should rest at least 3 minutes after a continuous starting
of 5 times. Due to different vehicle's performance, we
recommend using a higher capacity battery once the
battery is found weak power.
www.bs-battery.com
9
Publicidad
