Publicidad
Idiomas disponibles
Idiomas disponibles
To Use Humidifier
WARNING
A
Care and Maintenance
NOTE: This is an electrical appliance and requires attention when in use. Follow the recommended guidelines to
prevent mineral buildup from accumulating in the humidifier.
Extra large fill opening in the tank allows for quick cleaning of interior tank surface as needed.
PERIODIC MAINTENANCE
Remove Mineral Buildup/Scale:
1
Turn off unit and remove tank: Ensure humidifier is off and unplugged, then remove tank and drain water from
tank and base into sink. DO NOT place base in sink.
2
Base: Scale may build-up over time on the top surfaces of the base. To remove scale, gently wipe undiluted white
vinegar directly on all affected areas with paper towel, cloth or swab.
3
Tank: Partially fill with one 8-ounce cup of undiluted white vinegar. Leave in the tank for at least 30 minutes,
occasionally swishing the vinegar around inside the tank, then gently clean all interior tank surfaces with a soft
brush, cloth or sponge. Wipe the exterior of the tank with a cloth dampened with undiluted white vinegar. Rinse
tank thoroughly with clean water to remove the mineral and vinegar residue. Rinse a second time to ensure that all
residue has been removed.
STORAGE
1
Clean and rinse as directed above. Thoroughly dry ensuring no moisture is left. DO NOT leave any water in the unit
as this may render the unit inoperable for the following season.
2
Place in the original carton and store in a cool, dry place.
Troubleshooting
WARNING
Problems
• Unit does not turn on
• Unit is not plugged in or tank is not
seated properly
• White powder coming out
• High setting (mist can look like white
of humidifier
powder)
• Some minerals used in safe water
treatment could become white
powder as the water vaporizes. This
is not a humidifier malfunction
• Dampness in rooms on
• High setting
walls or windows
• Unit turns on and off
• Tank is almost empty
• The unit is dirty
• Humidifier is not on a level surface
so level sensor is not able to operate
properly
• Bubbles in the water or a
• Normal operation. As water enters
gurgling sound
reservoir in base, air is displaced and
creates bubbles in tank and possibly
a gurgling sound
• Water leakage
• Tank cap not properly tightened
• Water level in base reservoir may
be too high
• Product may have been mishandled
• An LED doesn't light
• Unit is not plugged in or the LED has
burnt out
• When the tank is removed, all but one
LED light will turn off
• No mist flow/mist flow
• Water level in base reservoir may
stops
be too high
Shut off humidifier before
removing tank from base.
Shut off humidifier before removing tank
from base.
Causes
Actions
• Plug in power cord or re-seat tank
• Adjust the setting
to reduce mist output
• Use distilled or filtered water instead
of tap water
• Turn unit off or adjust the
setting to reduce mist output
• Open door to room at least 6''
• Refill tank
• Clean unit (see Care & Maintenance)
• Put humidifier on a level surface and
refill tank
• No action necessary
• Readjust tank cap
• Empty water in base
• Discard humidifier, as it cannot be
*
repaired
• The LEDs are not replaceable
• Return tank to the base and LED lights
will turn on
• Empty water in base
1
Ensure the humidifier is switched OFF.
2
Select a location: Choose a flat and level surface 12 inches away from the wall. DO NOT
place on a finished floor or near furniture which can be damaged by too much moisture
or water. Place on a moisture-resistant surface.
3
Plug into a 120VAC electrical outlet. LED light will turn on once plugged in.
4
Remove and fill tank: Remove mist outlet cover. Use carry handle to lift tank off base and
bring tank to the sink. Remove cap on the bottom of tank and fill with clean, cool water,
ideally distilled (Figure A). Additives are NOT recommended. Replace cap, turn tank so that
cap faces down, and replace tank on the base. Be sure tank is flush with base. The tank will
immediately begin to empty into the base. Replace mist outlet cover.
NOTE: Use both hands when carrying full tank of water. It is normal for the water level in the
tank to decrease once full tank has been replaced on base. The water from the tank has simply
filled up the empty base. When the tank is removed, all but one LED light will turn off. Once the
tank is in place, all lights will illuminate.
5
Turn on: Turn knob on front of humidifier until power light glows. Mist will start flowing.
6
A djust mist direction: Rotate the mist outlet to set the desired output level.
7
Turn off: To manually shut off, turn knob on front of humidifier until power light turns off.
When water level is low, mist will automatically shut off.
NOTE: Knob only powers mist flow. LED light operates separately from mist function and is
safe to stay on. Leaving humidifier plugged in with LED light on allows for 24/7 sanitization.
8
Refer to back viewing window to see water level. NOTE: Back viewing window also
functions as a night light.
Question
• What are the variables that
affect run time?
• How do I remove mineral
buildup on the tank?
• How can I extend run time?
• How do I turn off LED
lights?
*
Each unit was tested after production and confirmed to be free of leaks.
2
One (1) Year Limited Warranty
Dorel Juvenile Group, Inc., warrants to the original
purchaser that this product (Stay Clean Humidifier), is
free from material and workmanship defects when used
under normal conditions for a period of one (1) year
from the date of purchase. Should the product contain
defects in material or workmanship Dorel Juvenile Group,
Inc., will repair or replace the product, at our option,
free of charge. Purchaser will be responsible for all costs
associated with packaging and shipping the product to
Dorel Juvenile Group Consumer Relations Department
at the address noted on the front of this document
and all other freight or insurance costs associated with
the return. Dorel Juvenile Group will bear the cost
of shipping the repaired or replaced product to the
purchaser. Product should be returned in its original
package accompanied by a proof of purchase, either a
sales receipt or other proof that the product is within
the warranty period. This warranty is void if the owner
repairs or modifies the product or the product has been
damaged as a result of misuse.
This warranty excludes any liability other than that
expressly stated previously, including but not limited to,
any incidental or inconsequential damages.
SOME STATES DO NOT ALLOW THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, SO THE ABOVE LIMITATION OR
EXCLUSION MAY NOT APPLY TO YOU.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS,
AND YOU MAY ALSO HAVE OTHER RIGHTS THAT MAY
VARY FROM STATE TO STATE.
Answer
• The estimated run time for this humidifier is based on average room conditions
and is dependent on numerous variables such as:
- Air exchange in the room.
- Room construction where the humidifier is placed.
- Temperature of the room.
- Humidity levels in the room.
- Movement of occupants and the opening and closing of doors in the room.
- Home furnishings in the room.
• See "Periodic Maintenence" section.
• Run your unit on the lowest setting.
• Fill tank all the way full and place on the base. Let water empty into the base
until it stops bubbling, then refill and re-seat tank again. This ensures maximum
water capacity and will extend run time.
• LED lights are intended to stay on 24/7 to keep sanitization technology
active. Unplugging the unit will turn off the LED lights, which will also stop
sanitization.
Publicidad
