Publicidad
ST EP 3
Using a 15mm masonry drill bit (if using the supplied anchor bolts) drill each hole 55-60mm
deep. Make sure these are clean and drilled level. Always vacuum out drilled holes before
installing the anchor bolts.
Warning: Ensure you are not drilling into water pipes, gas pipes or electrical wiring.
These may be recessed into a concrete or brick wall behind plaster or render. If in doubt
check with an expert.
Remove the bolts from the outer casing and tap into the wall. Be careful not to
ST EP 4
damage the casings.
S T E P 4 a
Hold the metal frame up to the wall and screw the bolts back in through the frame using the
security washers using an allen key wrench, tighten each bolt hand tight until the unit is
secure. Please note the larger holes in the framework allow for a small amount of adjustability.
Ensure unit is level and correct way up before fully tightening the bolts (and before inserting
ball
55 - 60 mm
Wal l
1 5mm
B o l t ca si n g s ho u l d be f l us h
w i th w a l l
Ta pe r e d nu t sh ou l d r e m ai n
i ns i de c a si n g
bearings).
Publicidad
