MHR 5518548B Manual Del Usuario página 5

Installation of electronic
control unit
Identify the electronic control unit
(Fig. 1, part. 1). The Malossi Digital
Electronic Coil is aesthetically
very similar to the original unit
facilitating installation.
• Remove the electronic coil
taking care to extract the original
connectors without damaging
them and thoroughly clean them.
• Assembly Malossi electronic
coil respecting the original
positioning and cables.
• Check that all connections have
been properly made.
Once the Malossi electronic control
unit has been installed, vehicle
diagnosis will no longer be able to
communicate with the diagnostic
tester. The Check Engine light
on the other hand maintains its
capacity to notify of any faults.
If problems are notified, we
recommend reinstalling the original
electronic control unit to check
the type of error by starting the
engine up. Of course, the engine
will not work properly because
the calibration is not compatible,
however this procedure will allow
you to store the engine's problems
on the electronic control unit in
order to solve them.
Bike with original setup
We recommend the use of Malossi
sports exhaust systems, in order to
obtain the best performance.
It is necessary to replace the main
jet with number 92 and to lift
the conical needle by one notch.
Recommended ratio: Z13/14.
ATTENTION:
The Malossi ECU is fully
interchangeable with the original
5
ECU. If any of the Malossi ECU's
wiring does not correspond with
the original wiring then DO NOT
PROCEED WITH THE INSTALLATION.
Malossi won't consider the warranty
if the ECU has been tampared.
Modifications to the ECU are
strictly prohibited. Malossi declines
any responsibility due to such
modifications.