EasyKeys F24 Instrucciones De Montaje

CaM LOCK aSSEMBLY
illustration 1
Lock bolt (position
straight up)
illustration 2
Retaining clip
Lock bolt
illustration 3
Lock bolt
Pointed end
Linkage piece
Square
end
Lock mechanism
Key
Lock cylinder
Knock-out hole
Cabinet
Lock
Inside wall
cylinder
of cabinet
Bend square
end with
screwdriver
read all instructions and review illustrations
before installing.
Tools required for assembly:
Straight blade screwdriver
Flashlight
This assembly includes:
(1) Lock cylinder
(1) Linkage piece
warning
removing a loaded drawer can cause the cabi-
net to tip and fall. To avoid injury, empty con-
tents of drawer before removing from cabinet.
Sharp edges may cause injury. Take care when
handling metal parts.
installation:
1. Remove contents from top drawer.
2. Remove top drawer from cabinet by opening com-
pletely, lifting front approximately 2-
out until free of cradle assembly.
3. Refer to Illustration 1. Locate knockout at upper
right corner of cabinet. On the outside of the cab-
inet, place punch at the center of knockout and tap
end of punch with the hammer.
4. Refer to Illustration 1. Rotate key in lock cylinder
so bolt is positioned upward. Insert lock cylinder
(with key in it) into hole in cabinet. Lock bolt
should be straight up when inserted.
nOTE
Ensure lock bolt is positioned straight up when
inserting lock cylinder into knock-out hole (or
filler) or lock cylinder will be difficult to install.
5. Rotate key clockwise
6. Refer to Illustration 2. Place retaining clip flush
against inside wall of cabinet. While holding lock
cylinder in place with one hand, slide retaining clip
over lock cylinder. Retaining clip prongs should fit
into grooves on top and bottom of lock cylinder.
7. Refer to Illustration 3. Insert pointed end of linkage
piece into predrilled hole in lock bolt (use the
flashlight if needed). Pivot linkage piece down-
ward and insert square end into lock mechanism.
8. Refer to Illustration 3. Use the screwdriver to bend
square end of linkage piece up to secure. Turn key
a few times to check operation.
9. Reinstall drawer by lowering rear of drawer into
cradle assembly and sliding drawer closed.
Carefully slide drawer open to verify drawer slides
freely and drawer stop operates properly.
10. Reload drawer.
Punch
Hammer
(1) Retaining clip
/ ", and sliding
1
2
/ turn.
1
4
42-2619F
(5/10)