Cleaning & Maintenance - bombol Pop-Up Booster Guia De Inicio Rapido

EN
IMPORTANT ! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE.
WARNING
!
Always use the restraint system and
ensure it is correctly fitted.
The restraint system needs to fit
closely but does not need to restrict
movements of the child.
When the child's back is touching the
backrest of the booster seat please
ensure that you can fit one or two
fingers between the child and the belts.
Check that the belts of the restraint
system aren't twisted or caught, as
this could cause an injury.
Always use the chair attachment
system and ensure it is correctly
fitted before use.
Always check the security and stability of
the product on the adult chair before use.
Fig.1. Mount on chair
Fig. 1 . 1 . Release the touch fastener lock.
Fig. 1 .2. Pull the ring until you hear a
clear " " to lock the booster firmly.
CLICK
Fig. 1 .3. Pass the large belt behind the
back rest of the adult chair. (For chairs
with armrests only, detach the
triangular hooks, pass them under the
armrests and lock them securely back
in the fabric loops.) Pass the buckles
under the seat of the adult chair.
Fig. 1 .4. Clip the buckle together. Pull
the loose end of the strap until the
safety strap is taut.
WARNING !
Check to ensure the booster seat
is firmly secured onto the adult
chair before the child is allowed
to use the booster seat.
Fig.2. Remove from chair
Fig.2. 1 . Release the buckle of the chair
attachment system under the seat of
the adult chair. (For chairs with
armrests only, release the buckle
of the chair attachment system under
the seat of the adult chair. Detach the
triangular hooks, pass them over the
armrests and lock them securely back
in the fabric loops).
Fig.2.2. To fold the Pop-Up booster do
the following two steps simultaniously:
6
DO NOT USE IN
MOTOR VEHICLES
This product is intended for children
able to sit up unaided (minimum 6
months) and up to 36 months or a
maximum weight of 15 kg.
Do not use if your child can open the
safety buckle on the restraint system
by him/herself.
Do not use this product on stools or
benches.
Adjust the restraint system with each use!
Do not use the product if some of its
parts are broken, torn or missing.
Do not use accessories or spare parts
not approved by the manufacturer.
A. Push the two side buttons of the
locking mechanism towards each
other and keep them pressed.
B. Push down the triangular support
of the back rest while rotating the
backrest backwards to fold up the
Pop-Up booster.
Fig.2.3.Pass the touch fastener lock
through the ring. Attach the touch
fastener strap to close the Pop-Up
booster in the flat position.
Fig.3. Lock & unlock
restraint system
Fig.3. 1 . Fasten the buckles. Make sure
you hear a clear " ".
CLICK
Fig.3.2. Push the button to release the
buckles of the restraint system.
Fig.4. Remove & mount
restraint system
Fig.4. The restraint system can be
removed for hand washing at 40°C.
When re-fitting the restraint system,
ensure the ends of the straps open out
again so they cannot accidentally
pull through the slots.
WARNING !
Always ensure the restraint
system is securely attached
before use by firmly pulling
the safety belts.
USER GUIDE
NEVER LEAVE THE HAZARD OF
CHILD UNATTENDED FALLING !
Prevent serious injury
death. Do not use this product in
motor vehicles, unstable chairs,
folding chairs, high chairs, floating
chairs or on unusually shaped seats.
Ensure that the adult chair with the
booster seat on top is placed in a
position where the child is not able
to use its feet to push against the
table or any other structure as this
can cause the tip over of the adult
chair supporting the booster seat.
Suitable for chairs wider than 26cm
or 10", deeper than 28cm or 1 1", with
backrest higher than 23cm or 9".
Cleaning & Maintenance
The maintenance and checking must
be regularly performed by an adult.
The booster seat can be cleaned by
sponging with warm water and a
mild detergent. Stubborn marks may
be removed with a non-abrasive
cream cleaner. Never clean with
abrasive, ammonia based, bleach
based or spirit type cleaner.
Protect from the weather: rain or snow.
Prolonged and continuous exposure
to bright sunlight may give rise to
colour changes of various materials.
Store this product in a dry place.
Keep moving parts (buckles, restraint
system, safety lock mechanism, ...)
clean and free of dust and sand.
Check the structure and attachments
for evidence of deterioration and
replace when required in accordance
with the manufacturer's instructions.
Check the product for exposed sharp
edges. Replace the product when
required or needed.
Do not iron. Do not dry clean.
Do not spin dry. Do not fully
submerge the booster in water
or