Firstech FTI-GMT3 Instrucciones De Instalación página 3

INSTALL GUIDE
Page 22 of 24
1
NOTE
I When programming, only one key fob will be used. The other
one must be located at least 10 feet away from the vehicle.
1
2
3
ENGINE
START/STOP
4
5
x1
ENGINE
START/STOP
6
7
WWW.IDATALINK.COM
Patent No. US 8,856,780 CA 2759622
COM-BLADE-AL(DL)-GM8-EN
CARTRIDGE INSTALLATION
Slide cartridge into unit. Notice
button under LED.
MODULE PROGRAMMING PROCEDURE
Remove battery from key fob.
Place key fob on key reader in
armrest or center console.
Close driver door.
Re-open driver door to wake up
data bus.
Push start button twice [2x] (or
press start button 5 seconds) to
ON position.
Wait, LED will turn solid RED.
Push start button once [1x] to
OFF position.
Wait, LED will fl ash BLUE
rapidly.
WARNING:
Disconnect power last.
Disconnect RS from vehicle.
2
8
9
10
ENGINE
START/STOP
11
12
x1
ENGINE
START/STOP
13
!
If the vehicle is equipped with a power liftgate:
Open and close the power liftgate with the OEM keyfob.
14
DOORLOCK INTERFACE
GENERAL MOTORS
20210331
Doc. No.: ##75068##
Ready for Module Programming
Procedure.
Connect RS to computer
and proceed with extended
programming.
WARNING: Do not press RS
programming button.
Connect power fi rst.
Connect RS to vehicle.
Push start button twice [2x] (or
press start button 5 seconds) to
ON position.
Wait, LED will turn solid BLUE
for 2 seconds.
Push start button once [1x] to
OFF position.
Remove key fob from key reader.
Insert battery in key fob.
Module Programming
Procedure completed.
Automotive Data Solutions Inc. © 2020