Close the water-resistant case, the holding mechanism and the lock.
Make sure that the water-resistant case shows no signs of damage.
Make sure that the holding mechanism of the water-resistant case is firmly closed and
that no dust or sand is found between the rubber seal and the case.
Make sure that the water-resistant back cover is being used – the open back panel is
not water-resistant! To replace the back cover, please read the next chapter "Replacing
the back cover".
Water-resistant back cover (incl. adapter)
Place one anti-mist pad each on the left and right between the camcorder
and the water-resistant case. This will prevent from mist forming on the
water-resistant case when using under water.
The anti-mist pads can be reused up to 4 times. You can dry out the anti-
mist pads by placing them into a 150°C hot oven for 5 minutes. When
not using them, store the anti-mist pads in an hermetically sealed
container.
Please note the following when using the camcorder under water or
when practicing sports related to water.
SilverCrest SCAA 5.00 A1
Open back cover
English - 133