Technical Specification - USAG 075 E Manual De Instruccion

3. Knob
Use to change range and function.
4. Terminal for: Volt-Ω-Hz - CAP e TEMP
5. GND
6. Terminal for: mA - TEMP
7. Terminal for 10A
Display
AUTO
HOLD
REL
DC
AC
mV
µ A - mA
Ω - kΩ - MΩ
Hz - kHz
µ F - nF - F
—

Technical specification

• Insulation: 600V CAT.III and 1000V CAT.II
• Operation environment: from 0 to 40 °C <80% RH
• Storage environment: from -10 to +50 °C
• Accuracy: see thecnical data page 17
• Voltage to ground max.: 750V AC RMS - 1000V DC
• Frequency response: from 40 Hz to 400Hz
• Overload protection A: uA and mA with fuse 0,5A-250V
• Sampling rate: approx. 3 time/sec
3
• Display: 3 / LCD 3999 auto polarity displaying
4
• Measuring method: dual-integral A/D transfer
• Overrange indication: LCD display "1" or "-1"
• Knob to change range and function
• Key to select auto range or manual range mode
• Low battery indication: "
Battery measurement
Auto range
This indicate that the display data is being held
Relative measuring mode
Diode test
Continuity test
Direct current
Alternating current
Function
Function
Function
Function
Function
Polarity
" displays
14
<80% RH
10A not fuse