Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT! READ AND FOLLOW THESE INSTRUCTIONS CAREFULLY AND
KEEP FOR FUTURE REFERENCE.
Warm Notice:
* Before installation, make sure the suitable screws for the surface.
x10
x10
*Shorter Screws are used
*Longer Screws and Expansion Screws are
on the wood surface.
used on solid wall such as concrete wall or tile wall.
* Before installtaion, make sure A3 & A4 to be used on which surface.
* If A3 & A4 are fixed on the same plane, compared to the
surface of A1 & A2, screws should be mounting on the
holes A3A and A4A.
* If A3 & A4 are fixed on the intersection angle, compared
to the surface of A1 & A2, screws should be mounting on
the holes A3B and A4B.
1 SET Spacer
* Build up the wall areas equivalent to thickness of baseboard (Skirt board) with spacers.
* To fit spacers to bracket and hook, follow the below step:
1. Spacer 1: SPA1 13mm thickness + SPA2 5mm thickness
2. Spacer 2: SPA1B 13mm thickness + SPA2B 5mm thickness
3. SPA1 & SPA1B can be single use for the baseboard(skirt board) in 13mm thickness
4. SPA2+SPA2B can be used together for the baseboard(skirt board) in 18mm thickness
5. Install the spacers under A1 or A4
Match A1
SPA1
Spacer 1
Skirting
board
SPA1B
Spacer 2
Match A4
www.costway.com
x10
+
SPA2
5mm
13mm
+
SPA2B
5mm
13mm
02
Clarify each part before installation
Preparation: Pen, Screwdriver
Fix A1 & A2 with screws on the surface firmly.
Install and fix the metal tube on A2 & A1.
Put the A5 to cover A1 firmly.
Fix A3 & A4 with screws on the surface firmly.
www.costway.com
Put Scale Direction L on the desired location,
make sure to suck the bottom line of A2 to the
floor and mark the screw holes of A1 & A2 on
the surface.
Install and fix the metal tube on A2 & A1.
Put Scale Direction R on the desired location,
make sure the bottom of A4 is 28mm to the
floor and mark the screw holes of A3 & A4 on
the surface.
03
Publicidad
