Parts Description; Technical Data; Safety; Safety Notices - LIVARNO home 14147606L Instrucciones De Montaje, De Uso Y De Seguridad

Parts description

Wall plugs
1
Mounting bracket
2
Locating screws (connection housing)
3
Screws (mounting bracket)
4
Lamp housing
5
Terminal block
6
Protective tube
7
Mains connection cable (external)
8
Connection box
9

Technical data

Model No.: 14147606L / 14147604 /
14147706L / 14147704L
Operating voltage: 230‒240 V∼ 50 Hz
Rated lamp power: LED 11.5 W non-replaceable
Protection class: II /
LED:
LED module: max. 11 W (non-replaceable)

Safety

Safety notices

Damage due to failure to comply with these operat-
ing instructions will invalidate the guarantee! We
assume no liability for consequential damage! We
assume no liability for material damage or personal
injury due to improper handling or failure to comply
with the safety instructions!
INJURY AND ACCIDENT HAZ-
ARD FOR TODDLERS AND
SMALL CHILDREN!
Never leave children unsupervised with the
packaging materials. The packaging material
poses a suffocation hazard. Children frequently
underestimate the dangers. Please always keep
the product out of the reach of children.
This device may be used by children aged
8 years and up, as well as by persons with
RISK OF FATAL
Introduction / Safety
reduced physical, sensory or mental capaci-
ties, or lacking experience and / or knowledge,
so long as they are supervised or instructed in
the safe use of the device and understand the
associated risks. Do not allow children to play
with the device. Cleaning and user maintenance
must not be performed by children without
supervision.
Avoid the risk of fatal injury
from electric shock
Ensure that a qualified electrician, or a person
trained to carry out electrical installations,
performs the electrical installation.
Always check the light, power supply, and
mains cable for damage before plugging it in.
Never use the light if it shows any signs of
damage.
A damaged mains cable indicates a life-threat-
ening danger due to electric shock. In the event
of damage, repairs or other problems with the
light please contact the service centre or a
qualified electrician.
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse box.
Prior to installation verify the mains voltage on
site corresponds with the operating voltage
required for the light (see "Technical data").
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the light on a wet or conductive
substrate!
Prevent fire and
injury hazards
Do not mount the light with defective lamps
and / or lamp lenses. In this case contact the
service centre for a replacement.
Do not look directly into the light source (light
bulb, LED etc.).
GB/IE 13