Kawasaki 691783 Manual De Instrucciones página 7

Check all screws and fastenings before use. Make sure the blade screw is
tight and secure.
Cut only one piece of material at a time. Leave enough room for the waste
piece to move once it is cut or it may become wedged against the blade and cre-
ate a hazard.
Be extremely careful when cutting pieces that are very large, very small or
oddly shaped. Make sure all oddly shaped pieces are held securely so they can-
not slip or cause kickback. Moulding should be clamped down flat before cutting.
DO NOT let the workpiece sag or bend. If necessary, use tables or sawhorses
to support the piece while cutting.
NEVER let your fingers get closer than 4 inches to the blade. You cannot cut
any workpiece that requires you to get your hand closer than 4 inches to the
blade.
NEVER allow bystanders behind the saw or close enough to the workpiece to
be hit by flying debris.
Round material such as dowel rods or tubing may roll when cut. Clamp
securely before cutting.
Check that the workpiece is free of nails or other foreign objects.
Make sure ventilation slots are clear of dust or debris.
Mount the saw to a work bench or table before use to prevent unexpected
saw movement. If the saw moves during use, it could cause injury to the oper-
ator and/or damage to the workpiece.
NEVER lubricate the blade while it is in motion.
Before moving the saw, make sure the cord is unplugged and the handle is
locked in the down position. To avoid back injury, do not attempt to lift the saw
by yourself.
Give the saw a test run before cutting. If the tool vibrates excessively or makes
unusual noises, stop operating the saw immediately and correct the problem.
Never hold or clamp the waste portion of the material. Cutoff pieces must be
free to move aside or they may wedge against the blade and cause injury to the
operator or damage to the workpiece.
If the blade becomes clogged with debris, release the trigger switch and let
the blade come to a complete stop before unplugging the tool and removing
the debris.
All manuals and user guides at all-guides.com
11
After finishing a cut, release the trigger switch and allow the blade to come
to a complete stop before raising the handle.
Make sure the blade is up to speed before lowering it into the workpiece.
Thoroughly clean the Cut-off Saw before changing types of workpieces.
Combining wood and metal dust can result in an explosion or fire. CONSULT
EXPERT ADVICE BEFORE CUTTING IN WORKPIECES MADE OF MAGNESIUM.
The friction generated by the abrasive wheel could cause the magnesium to
ignite resulting in a very intense fire that could cause severe burns to the oper-
ator and/or seriously damage the Cut-off saw.
Magnesium fires cannot be extinguished using fire extinguisher with an "A",
"B" or "C" rating. Only a class "D" extinguisher (for flammable metals)
should be used. Do not attempt to extinguish a magnesium fire with water or
other liquid. The result will be an explosive reaction that could result in
severe burns or death to the operator.
Do not use the side of the abrasive wheel as a deburring grinder. This will
substantially weaken the wheel causing an unsafe condition. The wheel
could come apart sending fragments in all directions. Failure to adhere to
this warning could result in serious damage to the tool and/or serious injury
or even death to the operator.
Do not alter in any way, shape, or form the upper and lower guards around the
abrasive cutting wheel. These guards are there to protect the operator against
unexpected conditions, such as breaking, of the cutting wheel. Any modifica-
tion of these guards voids the warranties set forth by the manufacturer.
12