Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: This tool is shipped completely assembled. No assembly time or tools are
required.
VACUUM HOSE
A standard 1" vacuum hose can be
attached to the dust port to connect the
tool to a vacuum cleaner or dust collection
system (Fig.1).
TEMPLATE GUIDE INSERT & OPTIONAL TEMPLATE GUIDES
The template guide insert is included with the router for use with optional template
guides. A wide variety of template guides is available for use in pattern and template
routing operations.
Disconnect the tool from the power source!
1.
Remove the clear dust cover (A) Fig. 2, and the three clear dust cover retaining
screws (B). (Use a slotted screwdriver or T20 torque wrench.)
2.
With the motor at its highest position, rotate the plunge locking lever (B) Fig.
8 left to the free motion position as far as it will go. The lever will lock into
position.
3.
Insert the template guide (A) Fig. 3 through the template guide insert (B), and
secure it with a locknut (C).
NOTE: Insert the template guide in the recessed area on the side of the template
guide insert (D) Fig. 3.
4.
Turn the router upside down and stand it on the motor cap (Fig. 4).
5.
Insert the template guide insert into the center of the sub-base (Fig. 4).
6.
Install the three screws provided (use the slotted screwdriver or T20 torque
wrench) and tighten until they stop, then back out 1/2 turn.
B
ASSEMBLY
OPERATION
C
A
Fig. 2
B
D
A
Fig. 3
9
Fig. 1
Fig. 4
Publicidad
Tabla de contenido
