TMC REEF DC-1200 Instrucciones De Instalacion Y Uso página 4

REEF-Skim DC Pump Instructions Multilingual v1-2014_Layout 1 21/10/2014 14:53 Page 3
All manuals and user guides at all-guides.com
INSTRUCTIONS FOR INSTALLATION AND USE
Important Safety Information - Please Read Carefully
These pumps are carefully inspected and tested to ensure both safety and operating performance.
However, failure to follow the instructions and warnings in this manual may result in damage to the
pump and/or serious injury. Please read and save this manual for future reference.
- Always isolate from the mains electricity before installing or carrying out any
maintenance to this pump.
- Power to this DC Pump must be supplied through a Residual Current Device (RCD) with a
rated residual operating current not exceeding 30mA.
- Pump rating: 24V unless marked otherwise.
- Do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning, or
if it has been dropped or damaged in any way.
- This pump is designed to be used indoors and is not suitable for any outdoor applications.
Drip Loop
- This pump must be fully submerged - maximum depth = 1.5m.
Do not allow to run dry.
- Do not use in water above 35
- This pump must only be used with the supplied PSU.
- Ensure this pump is safely positioned before operating.
- Always leave a drip-loop in the cable to prevent water running down the
cable and reaching the power source (see diagram).
- Dispose of this unit responsibly. Check with your local authority
for disposal information.
DC Pump
o
C.
1