TMC REEF DC-1200 Instrucciones De Instalacion Y Uso página 6

REEF-Skim DC Pump Instructions Multilingual v1-2014_Layout 1 21/10/2014 14:53 Page 5
All manuals and user guides at all-guides.com
2. Press "Feed" to pause pump operation for 10 minutes. The "10 min" will be illuminated
indicating the operation has been paused and will resume after 10 minutes have elapsed.
If you wish to restart the pump before the end of the 10 minute pause, press "Feed"again
and the pump will restart.
3. If the pump is allowed to run dry it will automatically cut off after 2 minutes. To restart,
unplug the cable from the mains electricity supply, make sure the pump is submerged, then
plug in again. The pump will restart.
MAINTENANCE
Caution: Always disconnect the pump from the mains electricity supply before carrying out
any maintenance.
1. Monthly maintenance will prolong your pump's life. To clean the pump, unplug from the
mains electricity supply, disassemble and use a small brush or stream of water to remove
any debris inside. Please Note: The pump shaft is NOT removable.
2. The impeller should be regularly checked for signs of degradation and replaced as
necessary.
TROUBLE-SHOOTING
If the pump fails to operate:
1. Check that the pump is connected to the electricity supply.
2. Check the pump inlets and outlets for any debris or blockages. Please flush out any debris
with fresh water.
3. Remove the pump inlet to access the impeller area. Turn the impeller to ensure it is not
broken or jammed.
3