Tabla de contenido
Publicidad
Safety Instructions-Veiligheidsrichtlijnen-Consignes de
Electrical safety
GB
Warning! When using electric tools, basic safety precautions should always be followed to reduce the risk of fire, electric shock
and personal injury. Read all these instructions before attempting to operate this product and save these instructions.
Always check if the mains voltage corresponds to the voltage on the rating plate.
Replacing cable or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones. It is dangerous to insert the plug of a
loose cable in the wall outlet.
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The minimum conductor size is 1.5mm
When using a cable reel always unwind the reel completely.
SPECIFIC SAFETY RULES
1.
work area
a.
Keep work area clean and well lit.
b.
Do not operate tools in explosive atmospheres, such as in the presence of flammable liquids, gasses or dust. tools
create sparks which may ignite the dust of fumes.
c.
Keep children away while operating tool.
2. Electrical safety
a.
Do not expose tools to rain or wet conditions. Water entering a tool will increase the risk of electric shock.
b.
Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the tool. Keep cord away from heat, oil,
sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock.
3. Personal safety
a.
Stay alert, watch what you are doing and use common sense when operating a tool. Do not use a tool while you are
tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating tools may result in
serious personal injury.
b.
Remove any adjusting key or wrench before turning the tool on. A wrench or a key left attached to a rotating part of the
tool may result in personal injury.
c.
Do not overreach. Keep proper footing and balance at all times. This enables better control of the tool in unexpected
situations.
d.
Dress properly. Do not wear loose clothing or jewelers. Keep your hair, clothing and gloves away from moving parts.
Loose clothes, jewelers or long hair can be caught in moving parts.
4. Tool use and care
a. Do not force the tool. Use the correct tool for your application. The correct tool will do the job better and safer at the
rate for which it was designed.
b. Store idle tools out of the reach of children and do not allow persons unfamiliar with the tool or these instructions to
operate the tool.
c. Damaged switches must be replaced at a customer service repair centre. Do not use tools that cannot be switched
on and off.
d. If the mains cable has been damaged, it must be replaced with a special mains cable. These can be obtained from
the manufacturer or the manufacturer's customer service department. The mains cable may only be replaced by
the manufacturer, the manufacturer's customer service department or equally qualified persons.
Version 201308 1.0
722310038GBNLFE
Sécurité-consignas de seguridad
2
.
Publicidad
Tabla de contenido
