SLD 3075 F
DESCRIPTION OF CONTROLS
1. SNOOZE / LIGHT button,clock temporary stop / dial
lighting
2. ALM ON / OFF button, alarm switches on-off
3. SET button, time format,
4. ALM SET button, setting alarm
5. KNOB+ / - adjustment Hours and Minutes
6. RESET button
POWER SUPPLY
Open the battery compartment and fit in two "AA" batteries,
carefully respecting the indicated polarities.
TIME SETTING
1. Press the SET button (3), the display will begin to flash.
2. Use the knob + / - (5) to adjust the hour and minute.
3. Press the SET button (3) to select the time display mode:
12H (displays the time in 12-hour format) or 24H (displays
the time in 24-hour format).
4. Press the SET button (3) to confirm the unit will beep.
ALARM SETTING
1. Press ALM SET button (4) the display will start to flash.
2. Use the knob + / - (5) to adjust the hour and minute.
3. Press ALM SET button (4) to confirm.
ALARM USE
1. Press ALM ON / OFF button (2) 1 times to activate the
alarm, the icon will appear on the display.
2. At the set time the alarm is activated. To turn it off press
the ALM ON / OFF button (2) 1 times.
SNOOZE FUNCTION
1. Through the SNOOZE / LIGHT button (1) You can tempo-
rarily turn off the alarm when it is sounding.
After 5 minutes, the alarm sounds again.
2. You can temporarily turn off the alarm several times.
3. To switch off the alarm press the ALM ON / OFF button (2)
1 time.
DISPLAY LIGHT
1. This appliance is equipped with an display illumination for
a perfect view of the entire display.
2. Press the SNOOZE \ LIGHT button (1) to illuminate the
display for 5 seconds.
Note: an excessive use of light could result in a reduced bat-
tery life.
RESET
If the unit does not operate properly, press the RESET button (6)
to restore the product.
CARE AND MAINTENANCE
Remove batteries if you do not intend using the device for a
long period of time.
Clean the outsides of your device using a damp soft cloth, and
at all times avoid using chemicals and abrasives.
TREVI follows a policy of ongoing research and development.
The products may therefore have features different from those
described.
English