Intended Use - Worx Professional WU652 Manual Del Usuario

Symbols
To reduce the risk of injury, user must read instruction manual
Double insulation
Warning
Wear eye protection
Wear dust mask
Wear ear protection
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your Local Authority or retailer for recycling advice.
Operating instructions
Note: Before using the tool, read the instruction book carefully.

INTENdEd UsE

The machine is intended for dry sanding of wood,plastic, metal and
filler material as well as painted surfaces.
Machines with electronic control are also suitable for polishing.
1
REplAcINg ThE sANd pApER/ sANdINg plATE
Remove the plug from the socket before carrying out any adjustment,
servicing or maintenance.
a) selecting the sand paper
Depending on the material to be worked and the desired material
removal, various Sand paper qualities are to be used:
- Use coarse grits to sand down rough finishes medium grit to
smooth the work and fine grit to finish off.
- The higher the grade number, the finer the grit. For rough work,
start with a low grade of grit. (e.g.60grit) and change to a higher,
finer grade (e.g.120grit) for finishing.
b) Replacing the sand paper
Lift the Sand paper at the side and pull it off the sanding plate. Clean
the sanding plate, if required. Press the new Sand paper against the
bottom of the sanding plate. To ensure optimum dust extraction, the
holes of the Sand paper must match with those of the sanding plate.
c) selection of the sanding plate
Depending on the application, the machine can be equipped with
sanding plates of different hardness
- Soft sanding plate: Suitable for polishing and sensitive sanding
(also for curved surfaces).
7