Switching On/Off - Worx Professional WU652 Manual Del Usuario

- Middle sanding plate: Suitable for universal usage on flat surfaces.
- Hard sanding plate: Suitable for high sanding performance on flat
surfaces.
d) Replacing the sanding plate (see Fig A)
To replace the sanding plate, pull off the sand paper or polishing tool.
Loosen and remove the screw.
Replace damaged sanding plates without delay.
- Dust produced while working can be detrimental to health,
inflammable or explosive. Suitable protection measures
are required. Examples: Some dusts are considered to be
carcinogenic. Use suitable dust/chip extraction and wear a dust
protection mask.
- Light metal dust can burn or explode. Always keep the work place
clean since material mixtures are especially dangerous.
caution: Fire hazard! For unfavorable conditions such as
flying sparks when sanding metals, sanding dust in the dust
bag, micro filter or paper sack (or in the filter sack or filter of
the wet/dry vacuum cleaner) can self-ignite, especially when
mixed with remainders of varnish, polyurethane or other
chemical materials and when the sanded work piece is hot
after long periods of working. Avoid overheating the object
being sanded as well as the machine and always empty the
dust container before pauses in the work.
2
INTERNAl VAcUUmINg WITh dUsT BAg (see Fig B)
Attaching the dust bag
Place the dust bag on the outlet piece and allow the latching lever to
latch.
Emptying the dust bag
Always operate your sander with the dust bag fitted. For the best
performance, always empty the dust bag in time. Open the zip and
empty the dust from the bag.
3
ExTERNAl VAcUUmINg
Use the extraction adapter (see Fig c)
Slide the extraction adapter onto the outlet piece and take care that
the latching lever engages. For removal, press the latching lever in at
the rear and pull off the extraction adapter.
External vacuuming
When sanding vertical surfaces, hold the machine so that the
extraction hose points downwards. The vacuum cleaner must be
suitable for the material to be worked. When vacuuming dry dust
that is especially detrimental to health or carcinogenic, use a special
vacuum cleaner.
4

sWITchINg ON/OFF

On /off switch
Depress to start and release to stop your tool.
lock-on switch
Depress on/off switch (2) then lock-on button (1), release on/off
switch first and lock-on button second. Your switch is now locked
on for continuous use. To switch off your sander just depress and
release the on/off switch.
5
AUxIlIARy hANdlE (see Fig d )
The auxiliary handle makes possible comfortable handling and
optimum force application, especially for high material removal. The
position of the auxiliary handle can be adjusted using winged screw.
8