For Your Safety; Tool Specifications; Operating Controls; Use As Intended - Würth 2000 Instrucciones Para El Manejo

GB
Working safely with this machine
is possible only when the opera-
ting and safety information are
read completely and the instruc-
tions contained therein are strictly
followed.
l Before each use, check the unit for full functional
capability. If the functional capability is not ensured or
if damage is detected, the unit should not be used.
l When compressing the spring, neither the spring
windings nor the pressure plates 4 (B) should come in
contact with each other.
l The centre line of the spring must always be parallel to
the compressing device 2, especially for conical
springs.

Tool Specifications

MacPherson Spring Strut Compressor
Article No. 0713 525 20
Max. pressure force 2000 kg (20000 N)
For cylindrical springs 80 - 195 mm dia.
For conical springs 80 - 145 mm dia.
Cylinder bolt for M 10 x 25 mm
pressure plates DIN 912, quality 12.9

Operating Controls

1 Drive nut
2 Compressing device
3 Bolts
4 Pressure plate
5 Spring pin
6 Outer rib
7 Safety ridge
8 Spring

Use as intended

The spring strut compressor is exclusively for compressing
and expanding of cylindrical and conical MacPherson
strut springs whereby suitable pressure plates must be
used.
Any other or further use is considered not as intended.
*Sonderbeschaffung/Special order

For Your Safety

l Use only suitable pressure plates 4 for the springs.
The spring 8 must rest securely within the outer rib 6
and the safety ridges 7 (D). Take care that sliding of
the spring 8 out of the pressure plates 4 is not
possible (D).
l The bolts 3 of the pressure plates 4 must always be
firmly tightened.
l For repair, use only original parts, especially for
conical springs.
l Do not make any construction changes to the unit.
Do not replace the spring pin 5 by a stronger spring
pin (C).
Article No.
Standard Accessories
0713 525 20
0713 525 01
0713 525 02
0713 525 21
Special Accessories
0713 525 03*
0713 525 05
0713 525 06
0713 525 07
0713 525 15*
0713 525 16*
26
Basic Models
and Accessories
Designation
Spring compressor complete
with 4 pressure plates for springs
with 80 - 195 mm dia.
Pressure plate III for springs
with 80 - 145 mm dia.
Pressure plate V for springs
with 145 - 195 mm dia.
Compressing device
Pressure plate VII
180-230 mm springs
Pressure plate pair VIII + IX
Peugeot 305, Citroen C15 rear
axle
Pressure plate II 80 - 120 mm
springs
Pressure plate X for conical springs
with 80 - 145 mm dia.
Pressure plate XI BMW E 39-46
Pressure plate IV for springs
with 140 - 175 mm dia.
Mercedes C 203