Tabla de contenido
Publicidad
Angle polisher
TECHNICAL SPECIFICATIONS
PRODUCT ELEMENTS
1. Spindle-lock button
2. Auxiliary handle
3. On/off locking switch
4. Switch locking knob
5. Speed adjustment wheel
SAFETY
WARNING! Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire
and/or serious injury.
• This tool should not be used by people under the age of 16 years
• Always disconnect plug from power source before making any adjustment or changing any accessory
ACCESSORIES
• Use the original accessories which can be obtained from your local dealer
• For mounting/using non- original accessories observe the instructions of the manufacturer concerned
• Use only accessories with an allowable speed matching at least the highest no-load speed of the tool
OUTDOOR USE
• Connect the tool via a fault current (FI) circuit breaker with a triggering current of 30 mA maximum
• Only use an extension cord which is intended for outdoor use and equipped with a splashproof coupling-
socket
BEFORE USE
• Before using the tool for the fi rst time, it is recommended to receive practical information
• Use completely unrolled and safe extension cords with a capacity of 16 Amps (UK 13 Amps)
• Wear protective glasses and gloves, hearing protection and sturdy shoes; when necessary, also wear an
apron
• Be sure tool is switched off when plugging in
DURING USE
• Always keep the cord away from moving parts of the tool; direct the cord to the rear, away from the tool
• If the cord is damaged or cut through while working, do not touch the cord, but immediately disconnect the
plug; never use the tool with a damaged cord
• Push spindle-lock button only when spindle is at a standstill
• Keep hands away from rotating accessories
• In case of electrical or mechanical malfunction, immediately switch off the tool and disconnect the plug
• In case of current interruption or when the plug is accidentally pulled out, unlock the on/off switch
immediately and put it in the OFF-position in order to prevent uncontrolled restarting
• Do not apply so much pressure on the tool that it comes to a standstill
AFTER USE
• Before you put down the tool, switch off the motor and ensure that all moving parts have come to a complete
standstill
• After switching off the tool, never stop the rotation of the accessory by a lateral force applied against it
WHEN CONNECTING NEW 3-PIN PLUG (U.K. ONLY):
• Do not connect the blue (= neutral) or brown (= live) wire in the cord of this tool to the earth terminal of the
plug
• If for any reason the old plug is cut off the cord of this tool, it must be disposed of safely and not left
unattended
Your machine is double insulated in accordance with EN60745; therefore no earthwire is required.
MAINTENANCE
5
Publicidad
Tabla de contenido
