Tabla de contenido
Publicidad
Belt sander
INTENDED USE
TThis tool is intended for dry sanding with high removal performance of wood, plastic, metal, etc.
TECHNICAL SPECIFICATIONS
PRODUCT ELEMENTS
1 On/off switch
2 Knob for locking on/off switch
3 Lever for changing sanding belt
4 Arrow
5 Knob for adjusting belt centering
6 Dustbag
SAFETY
WARNING! Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire
and/or serious injury.
• Avoid damage that can be caused by screws, nails and other elements in your workpiece; remove them
before you start working
• Always keep the cord away from moving parts of the tool; direct the cord to the rear away from the tool
• When you put away the tool, switch off the motor and ensure that all moving parts have come to a complete
standstill
• Use completely unrolled and safe extension cords with a capacity of 16Amps (U.K. 13Amps)
• In case of electrical or mechanical malfunction, immediately switch off the tool and disconnect the plug
• WORLDPRO can assure fl awless functioning of the tool only when original accessories are used
• This tool should not be used by people under the age of 16 years
• The noise level when working can exceed 85 dB(A); wear ear protection
• If the cord is damaged or cut through while working, do not touch the cord, but immediately disconnect the
plug
• Never use tool when cord is damaged; have it replaced by a qualifi ed person
• Always check that the supply voltage is the same as the voltage indicated on the nameplate of the tool (tools
with a rating of 230V or 240V can also be connected to a 220V supply)
• This tool is not suitable for wet sanding
• Do not work materials containing asbestos (asbestos is considered carcinogenic)
• When sanding metal, sparks are generated; do not use dustbox and keep other persons and combustible
material from work area
• Do not touch the moving sanding sheet
• Do not continue to use worn, torn or heavily clogged sanding sheets
• Wear protective gloves, safety glasses, close-fi tting clothes and hair protection (for long hair)
• Take protective measures when during work dust can develop that is harmful to one's health, combustible or
explosive (some dusts are considered carcinogenic); wear a dust mask and work with dust/chip extraction
when connectable
• Always disconnect plug from power source before making any adjustment or changing any accessory WHEN
CONNECTING NEW 3-PIN PLUG (U.K. ONLY):
• Do not connect the blue (= neutral) or brown (= live) wire in the cord of this tool to the earth terminal of the
plug
• If for any reason the old plug is cut off the cord of this tool, it must be disposed of safely and not left
unattended
• The dust suction requires the use of perforated sanding sheets
• Perforation in sanding sheet should correspond with perforation in sanding foot
• Replace worn sanding sheets in time
• Always use the tool with the total sanding surface covered with sanding paper
• Before the sanding surface reaches the workpiece, you should switch on the tool
• Before switching off the tool, you should lift it from the workpiece
3
Publicidad
Tabla de contenido
