Structure And Connection - Blumfeldt Aquanova Manual

EN
16

STRUCTURE AND CONNECTION

Fill a bucket with water and immerse the detector unit (10) at the
1 bottom of the pole in the water. Hook the control panel housing into
the side wall of the bucket (1).
2
Set up the plants to be watered (maximum 10).
Open one of the outlet caps on the connector (8) and insert one end
3 of the hose into the outlet. To do this, you need to cut one end of the
hose at a slight angle.
Insert the other end of the hose into the flower pot you want to
water. Cut the hose so that it is long enough to reach the bottom of
the flower pot (6). Secure the end of the hose with a peg in the flower
4 pot (see pictures below). Do the same with the other flower pots you
want to water. Please note that the amount of watering depends on
how many plants you are watering at the same time. You will find a
reference table at the end of the operating instructions.