Stand Assembly - Kobalt KMS-S16 Manual Del Usuario

ASSEMBLY INSTRUCTIONS

STAND ASSEMBLY

1. Align the holes on the handle (F) with holes on the
miter saw stand (D). Insert the hexagon bolts M6 x 30
mm (CC) through flat washers 6 (JJ) and into the
mounting holes on the handle and miter saw stand.
Tighten the hexagon bolts M6 x 30mm (CC) with 5mm
hex key (G).
Hardware Used
Hexagon bolt
CC
M6 x 30mm
JJ
Flat washer 6
2. Attach two wheels (B) to the miter saw stand (D) with
two bolts M8 x 90mm (AA), washers 14 (EE), washers
10 (FF), wheel sleeves (DD), big flat washers 8 (GG)
and locking nuts M8 (HH).
Tighten locking nuts M8 with 13mm open-end wrench
or adjustment wrench (not supplied).
Hardware Used
AA
Bolt M8 x 90mm
DD
Wheel sleeve
EE
Washer 14
FF
Washer 10
GG
Big flat washer 8
HH
Locking nut M8
1
JJ
CC
x 2
x 2
2
EE
AA
x 2
x 2
x 2
x 2
x 2
x 2
8
F
D
G
FF HH
GG
DD
B
kobalttools.com