Greencut MH202-4 Manual De Instrucciones página 55

SANDING
FITTING/REMOVAL OF THE SANDING SHEET
The sanding plate is fitted with a Velcro fastener for quick attachment of the sanding sheet.
1. Press the sanding sheet evenly onto the sanding plate. Make sure that the holes in the sanding sheet are
located above the openings in the sanding plate.
2. To remove the sheet simply remove the sanding sheet from the sanding plate.
DUST EXTRACTION CONNECTION
You can reduce dust production during sanding by connecting a dust extraction system.
1. Insert the adapter into the opening of the sander attachment as far as it will go.
2. Connect a dust suction hose to the adapter.
NOTE: If necessary, you can connect the suction hose of a hoover without a reducer to the adapter.
JIGSAWS
ATTENTION: Do not use blunt or bent saw blades or blades damaged in any other way. Always use
a suitable saw blade.
SAW BLADE INSTALLATION/CHANGE
1. Push the saw blade release lever (5) upwards as far as it will go. Push the saw blade shaft into the saw blade
mounting groove.
2. To unlock, release the lever, it will return to the initial position.
3. Check that the saw blade is secure by pulling on it.
4. To remove the saw blade, press the lever (5) for unlocking the saw blade upwards to the stop and then pull
the saw blade out of the saw blade holder.
HANDLING THE JIG SAW
ATTENTION: Before switching on the device, make sure that it is not in contact with the workpiece.
1. Switch on the appliance using the on/off switch (11), the rotation speed can be progressively adjusted.
Gentle pressure: low travel speed.
Higher pressure: higher stroke speed.
2. Place the footrest on the workpiece.
3. Cut with an even feed movement.
4. When the work is completed, first remove the blade from the cut-off saw and switch off the device.
NOTE: The on/off switch cannot be locked.
MULTIFUNCTIONAL TOOL
INSERTION OF ACCESSORIES
1. Push the tool release lever upwards as far as it will go.
2. Pull the unlocked tool holder forwards.
3. Place the desired tool in the spindle. 12 different positions are possible.
4. Push the tool holder back into the central mounting.
5. Push the tool release lever forward again. The tool holder is fixed to the tool.
55
EN