Installing This Unit - Pioneer AVG-VDP1 Manual De Instalación

Installation

Installing this unit

1. Attach the side brackets to this unit.
When this unit is installed on the floor or
the installation board under the passenger
seat, etc., the side brackets should be
attached to the unit.
Use the following holes in the side
brackets.
If the positions of the side plates
are shifted in parallel you can also
use other holes that match up with
the holes in this unit.
This unit
Side bracket
When this unit is installed under the pas-
senger seat, etc., use the installation board.
11
All manuals and user guides at all-guides.com
Washer faced
screw (4 × 8 mm)
2. Decide on the installation position,
and drill the holes.
Installation board
Drill holes of between
4 and 4.5 mm in
diameter.
3. Secure it firmly using the self-tap-
ping screws.
Self-tapping screw
(6 × 16 mm)
Mark up the positions for
drilling the holes.