Pioneer AVG-VDP1 Manual De Instalación página 4

Connecting the Units
WARNING:
• To avoid the risk of accident and the
potential violation of applicable laws,
certain functions of this unit should
never be used while the vehicle is being
driven. Also, rear displays should not be
in a location where it is a visible distrac-
tion to the driver.
• In some countries or states the viewing
of images on a display inside a vehicle
even by persons other than the driver
may be illegal. Where such regulations
apply, they must be obeyed.
3
All manuals and user guides at all-guides.com
CAUTION:
• PIONEER does not recommend that
you install or service your Vehicle
Dynamics Processor yourself. Installing
or servicing the product may expose you
to risk of electric shock or other haz-
ards. Refer all installation and servicing
of your Vehicle Dynamics Processor to
authorized Pioneer service personnel.
• Secure all wiring with cable clamps or
electrical tape. Do not allow any bare
wiring to remain exposed.
• Do not drill a hole into the engine com-
partment to connect the yellow lead of
the unit to the vehicle battery. Engine
vibration may eventually cause the insu-
lation to fail at the point where the wire
passes from the passenger compartment
into the engine compartment. Take
extra care in securing the wire at this
point.
• It is extremely dangerous to allow the
GPS antenna cable to become wound
around the steering column or shift
lever. Be sure to install the unit in such
a way that it will not obstruct driving.
• Make sure that wires will not interfere
with moving parts of the vehicle, such as
the shift lever, parking brake or seat
sliding mechanism.
• Do not shorten any leads. If you do, the
protection circuit may fail to work
properly.