Clock Mode; Setting The Clock Time - Coby CDRA147 Manual De Instrucciones

All manuals and user guides at all-guides.com

Clock Mode

Setting the Clock Time

Make sure the unit has been turned off before setting the
time.
To toggle the clock display between 12-hour mode and
24-hour mode:
Press and hold STOP/CLOCK ADJ [8] for 3 seconds.

The screen will display "12H" for 12-hour mode, or
"24H" for 24-hour mode.
To change modes again, wait until the normal clock

display returns, then press and hold STOP/CLOCK ADJ
[8] again.
The PM indicator will light up in 12-hour mode to
indicate PM hours.
To set the clock time:
Press STOP/CLOCK ADJ [8] once. The screen will begin

to flash.
While the screen is flashing:

Press SKIP NEXT/HOUR [11] to adjust the hour.
—
Press SKIP PREV/MINUTE [9] to adjust the
—
minutes.
Press STOP/CLOCK ADJ [8] to finish setting the time.

Page 8 Coby Electronics Corporation