Publicidad
E
Push Bar
Barre de poussée
Pulsador de barra
Navigation Buttons
Touches de navigation
Botones de navegación
LIGHT Button
Touche LIGHT (éclairage)
Botón de luz
E
OPERATION
PUSH BAR
Press the push bar to open or close the door.
NAVIGATION BUTTONS
Use the navigation buttons to make selections and program
features.
GARAGE DOOR OPENER LIGHTS
Press the LIGHT button to turn the garage door opener lights on
or off. When the lights are turned on they will stay on until the
LIGHT button is pressed again, or until the garage door opener is
activated. Once the garage door opener is activated the lights will
turn off after the specified period of time (the factory setting is
4-1/2 minutes). The LIGHT button will not control the lights when
the door is in motion.
MOTION SENSOR
This feature will automatically turn on the garage door opener
lights when motion is sensed. The lights will come on for the set
period of time, then shut off.
LIGHT FEATURE
The lights will turn on when someone enters through the open
garage door and the safety reversing sensor infrared beam is
broken.
If using the garage door opener light as a work light, turn the light
on using the light button on the wall control or the light will turn
off if you are beyond the range of the sensor.
Screen
Écran
Pantalla
Motion Sensor
Détecteur de mouvement
Detector de movimiento
TIMER-TO-CLOSE (TTC)
DO NOT enable TTC if operating a one-piece door. TTC is to be
used ONLY with sectional doors.
Once the TTC has been set and the door is open, the selected
close interval will be displayed on the screen and toggle between
the time and TTC message. The garage
door opener will beep and the lights will
flash before closing the door.
When the TTC is on the following
message will display on the door
control:
To temporarily suspend the TTC feature
press and release the HOLD button.
Press REL button to resume normal TTC
operation.
The TTC feature will deactivate if the garage door encounters two
sequential obstructions; or the safety reversing sensors are
incorrectly installed. The garage door will reverse open and WILL
NOT close until the obstructions are removed or the safety
reversing sensors are correctly installed.
When the obstruction has been cleared
or the safety reversing sensors have
been aligned, the door will close when
the garage door opener is activated.
3
LOCK
When the Lock feature is on, your remote controls have
been disabled and the following message will display on the
door control:
BATTERY BACKUP ONLY
If your garage door opener has a battery backup one of the
following messages will display on the door control if there
is a problem with the battery:
Publicidad
