X-Micro XWL-11GRTX Guía De Instalación Rápida página 8

Interfaces
1. Antenna
2. Reset
3. WAN
4. LAN
5. Power
Installation
Step One – Power On X-Micro WLAN 11g Broadband Router
Connect DC 7.5V Power Adapter to X-Micro WLAN 11g Broadband Router and the wall power socket.
Notice: It will take about 55 seconds to complete the boot up sequence after powered on the
X-Micro WLAN 11g Broadband Router; Power LED will be active, and after that the WLAN
Activity LED will be flashing to show the WLAN interface is enabled and working now.
Step Two – Configure X-Micro WLAN 11g Broadband Router
1. Connect your PC to LAN port for configuration setting
WLAN Broadband Router is delivered with the following factory default parameters on the Ethernet LAN
interfaces.
Default IP Address: 192.168.1.254
Default IP subnet mask: 255.255.255.0
All manuals and user guides at all-guides.com
Antenna
LAN
WAN
Description
The Wireless LAN Antenna.
Push continually the reset button 5 ~ 10 seconds to reset the configuration
parameters to factory defaults.
The RJ-45 socket allows WAN connection through a Category 5 cable. Support
auto-sensing on 10/100M speed and half/ full duplex; comply with IEEE 802.3/
802.3u respectively.
The RJ-45 sockets allow LAN connection through Category 5 cables. Support
auto-sensing on 10/100M speed and half/ full duplex; comply with IEEE 802.3/
802.3u respectively.
The power jack allows an external DC +7.5 V power supply connection.
The external AC to DC adaptor provide adaptive power requirement to
theX-Micro WLAN 11g Broadband Router.
7
Reset
Power