Using Magicspeed - Dometic GROUP Waeco MagicSpeed MS-BE3 Instrucciones De Montaje Y De Uso

MagicSpeed Accessory
10

Using MagicSpeed

MagicSpeed is controlled using the button on the control panel.
Enabling and disabling MagicSpeed
➤ Press the ON/OFF button once to switch on the speed regulator.
✓ The LED on the control panel lights up.
➤ When the speed regulator is switched on, press the ON/OFF button once
to switch it off.
✓ The LED on the control panel goes out.
✓ The last saved speed will be discarded.
Saving your desired speed
Use the SET/ACC button to save the speed you want on the speed regulator.
NOTICE!
A
The engine can be damaged if the speed is too high. Save the de-
sired speed whilst underway when you are travelling at that speed.
➤ Press the SET button and let go again immediately to set the speed you
are currently driving.
This set speed is maintained until:
– You press the brake or clutch pedal
– You switch off the device with the ON/OFF button
– The car slows down to below the lower activation speed
– The speed drops on a slope by more than 25%.
➤ Press and hold down the SET button to accelerate the car.
When you let go of the SET button the speed regulator records the cur-
rent speed and saves it.
EN
Using MagicSpeed
27