Triton Blue SHOW-REC-1024 Manual De Usuario página 15

RECORD
Data of lighting show can be recorded from the Ethernet network , WiFi or 2 DMX inputs. Each memory can be stored
up to 20 hours.
1. Press RECORD button and its LED is lit up.
2. Use UP/DOWN to select record modes as below.
3. Press MEM1-MEM14 button to select Memory for recording. The LED of selected Memory is blinking and
corresponding number "MEMX(1-14)" will be showed on LCD.
4. Press button to start recording,
"err:- " means no error. when there is error during recording,
then error code displays err: x (x=code).
MEMORY SET
Each MEMORY can be recorded in "over time" or "step by step" mode.
Follow the following steps to set MEMORY type before recoding.
to pause and
User Manual | SHOW-REC-1024 by Triton Blue | October 2021 | www.triton-blue.com
to end recording.
15.