Triton Blue SHOW-REC-1024 Manual De Usuario página 16

REPLAY
Replay can be in solo or loop mode. And replay can be operated on the unit or iPhone/iPad via TouchOSC.
Replay on unit
1. Press REPLAY button and its LED is lit up. The unit goes to last stadus of replay.
2. Use and
3. In loop mode, LED indicator of
The LED indicators of selected memory are lit up and the blinking one is in running.
4. When in loop mode, press
blinking. In solo mode, the selected MEM (memorie) are lit up. Press the selected one to run in solo mode
and its LED is blinking.
5. Use SPEED knob to adjust running speed from 25% to 200%. Use DIMMER knob to adjust output from 0 to
100%.
NOTE: MEM button without recording data can't be selected in REPLAY.
Replay on a iPhone/iPad
In order to use a iPhone or iPad to control the RECORDER, you need to install TouchOSC and upload the inter-face of
RECORDER on your iPhone/iPad.
1. Download TouchOSC from Apple Stores and install it on your iPhone/iPad.
2. Click on OSC and run it on your iPhone/iPad.
3. Power on RECORDER.
4. Connect your iPhone/iPad with the RECORDER. Click WLAN setup on your iPhone/iPad and select DMX AIO
xxx (xxx=000-999). Password is 12345678.
5. Download TouchOSCEditor.exe ( https://hexler.net/software/touchosc) and install it on your PC/laptop.
6. Run TouchOSCEditor, click "Open" and select "W-RECORDER1024.touchosc" file on your PC/laptop.
16.
button to run in loop mode,
(or ) is blinking.
button to pause, press
User Manual | SHOW-REC-1024 by Triton Blue | October 2021 | www.triton-blue.com
button to run in solo mode.
and button indicate the dirrection of running.
button again to enter solo mode and its LED is