Technical Specifications; Maintenance And Inspection - Metal Works CAGS25T Manual

1 Technical specifications

Model Capacity Min. height
CAGS25T 25 t
CAGS25TH 25 t
2 Security
Read these safety warnings before operation.
WARNING !
Failure to heed these warnings may result in loss of load, damage to jack stands, and/or jack stand failure
resulting in personal injury or property damage.
WARNINGS !
• Don't overload jack stands beyond rated capacity.
• Overloading can cause damage to or failure of the jack stands.
• Position load on center of saddle only.
• Always use stands in pairs on hard level surface capable of sustaining the load.
• Use of stands on other than hard level surfaces can result in stand instability and possible loss of load.
3 Operation
1. Refer to your vehicle owner's manual for proper jacking procedures.
2. Position stands under vehicle at points specified by vehicle manufacturer as
proper load support points.
3. To adjust stands:
1) Remove the pin and set the jack stand at the required height.
2) Insert the pin to lock the position.
4. Carefully lower the load onto stands.

4 Maintenance and inspection

1. Visual inspection shall be made before each use of the stands, checking for cracks, cracked welds and
missing and/or damaged parts. Any stand that appears to be damaged in any way shall be removed
from service immediately.
2. Because of the potential hazards associated with the misuse of equipment of this type, no modifications
shall be made to the product.
4
®
415 mm
675 mm
754751225 - 754751227 - NLFGBE - v1.0 -12072013
Max. height
640 mm
1050 mm
Base dimensions
330 x 330 mm
330 x 330 mm
EN
Saddle
Center
column
Pin
Base