Thorsen 19-014 Manual Del Usuario página 12

Tester and Charger:
Tester and Charger: When fi rst turned on, the unit operates only as a tester, not
as a charger. To continue to use it only as a tester, avoid pressing the CHARGE
RATE button. Selecting a charge rate activates the battery charger and deactivates
the tester.
Power-Up Idle Time Limit:
If no button is pressed within 15 minutes after the battery charger is fi rst powered
up, the charger will automatically switch from tester to charger, if a battery is
connected. In that case, the battery will be set for the 2A charge rate and 12V
REGULAR battery type.
Tester without Time Limit:
If either the DISPLAY MODE or BATTERY TYPE button is pressed within the fi rst
10 minutes after the battery charger is powered up, the unit will remain a tester
(not a charger) indefi nitely, unless a charge rate is selected.
Testing After Charging:
After the unit has been changed from tester to charger (by selecting a charge
rate), it remains a charger. To change the battery charger back to a tester, press
the CHARGE RATE switch until all charge rate LED's are off.
Tester Status LED's:
When the unit is operating as a battery tester, the status LED's light under the
following conditions:
• The CHARGED (green) LED will light if a charged battery is tested.
• The CHARGING (yellow) LED does not light in the battery test mode.
• The CONNECTED (red) LED lights when a properly connected battery
is detected.
• When the tester display mode is set to VOLTAGE, the CHARGED and
CHARGING LED's won't light.
12
15, 10 & 2 AMP FULLY AUTOMATIC
INTELLI-FAST BATTERY CHARGER
THORSEN Intelli-Fast Battery Charger
#19-014 #19-014