Uline H-6972 Manual Del Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Tap the top down around the edges with a rubber
mallet until the locking tabs on the side and back
panels snap into the square holes on the supports.
(See Figure 11)
Back
Support
Figure 11
CENTER SHELF INSTALLATION
1. At the desired shelf height, insert 2 shelf clips (7) into
the holes located inside the front edges of the side
panels. (See Figure 12)
Figure 12
7
2. Angle a shelf (6) into the cabinet above the installed
clips with its rear tilted down. (See Figure 13)
3. Insert the rear of the shelf into the slots in the back
panels that are closest in height to the installed clips.
(See Figure 13)
PAGE 4 OF 12
ASSEMBLY CONTINUED
Tabs
locked into
Square
Side
Holes
Support
4. Tilt the shelf down until it rests on the shelf clips. If
the shelf is uneven, reposition the shelf clips into
appropriate locations to level it. (See Figure 13)
Figure 13
5. Repeat this process for all of the center shelves.
NOTE: After assembly is complete, mild soap
and water can be used to clean the unit by
wiping with a soft cloth.
1-800-295-5510
uline.com
7
6
0721 IH-6972

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

H-6973H-6974H-7689

Tabla de contenido