Uline H-6570 Instrucciones De Asamblea

H-6570
6' LAGUNA BENCH
TOOL NEEDED
Power Drill
3/8" Spacer x 2
Left Leg x 1
NOTE: Two people are required to assemble
this bench.
CAUTION! Do not drive attachment screws too
deeply, as the screw could protrude through
slat on the seating side of bench.
1. Verify all parts are present before beginning.
2. With one person holding the left leg and another
person holding the right leg, insert a rounded-edge
board between each leg, in line with the front of
the legs. From underneath, attach the front board
to the supports by fastening screws through the
pre-drilled holes on the underside of the leg. Do not
overtighten. (See Figure 1)
PAGE 1 OF 6
1-800-295-5510
uline.com
Two Person Assembly
Phillips Bit
(Optional)
Seat and Back
Board x 6
Center Leg x 1
PARTS
Right Leg x 1
ASSEMBLY
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Front and Top Board
with Rounded Edge x 2
2" Screw x 64
Figure 1
1020 IH-6570