BeeSecure BEE-LOCK P1 Manual Del Usuario página 6

V1.0
2.2 Initiate BEE-LOCK P1 and set up Master User Passcode
Before you use the lock, you need to initiate the lock with the factory default code and set
up the master user passcode.
The factory default code is : 0123456
Follow the steps below to initiate your lock
Step
1 Press # for 3 times
2
Enter Default code 0123456 and
press # to confirm
3
Enter Master User passcode, e.g.
135790 and press # to confirm
4
Repeat Master User passcode and
press # to confirm
During the process, if you hear long beep, it indicates you that the operation failed. Please
try again from step 1.
Example: Input factory default code 0123456 and set up master code 135790:
###0123456# 135790# 135790#
Important Notice: When you choose a passcode, avoid obvious combinations such as the
numbers of your date of birth or part of your telephone number or zip code. Remember to keep
your passcode confidential. If you would like to write down the code, please keep it stored in a
safe place.
Furthermore, the access code must consist of a minimum of 6 and a maximum of 10 digits. Make
sure you choose a strong access code. If you create a new code, the lock will check whether it is
not a consecutive series of numbers. The lock will also give an error message if you use a code
that has already been selected by another user.
Open the Lock
Step
Enter your Passcode ,e.g. 135790,
1
followed by #
Rotate the external knob in
clockwise direction. Rotate within 6
2
seconds before the lock auto locks
itself.
Operation
Operation
Keyboard
Key
Light
### Green flash x2
0123456# Green flash x2
135790#
Green flash x2
135790# Green flash x2
Keyboard
Key
Light
135790#
Green flash x2
English
Signal
Sound
Do-re-mi
Beep-beep
Do-re-mi
Signal Sound
Do-re-mi