BeeSecure BEE-LOCK P1 Manual Del Usuario página 7

V1.0
Re-Lock the lock
You can always add extra re-lock to double secure the safety of the lock. Follow the steps
below:
a) From Outside: Enter correct passcode and rotate the external knob in anti-clockwise
direction within 6 seconds. Six seconds later, the lock automatically switches to sleep
mode and can't be opened.
b) From Inside: rotate the internal knob in anti-clockwise direction without inputting
code or time limitation
2.3 Installation
To install BEE-LOCK P1, all the tools needed are included in the package. No need of drills or
wires to install it.
There are 4 steps to install the BEE-LOCK P1
You can adjust the position of the knob to adjust to your door if necessary. The external
cylinder can be extended by 5mm per gap to a maximum of 15mm. The internal cylinder can
also extend to 15mm.
1. Remove the current cylinder from your door
1
2. Push the external knob into the mounting plate and extend the external length or use
one of the supplied cylinder covers (2,5mm and 5.0mm) if necessary and secure the
cylinder.
If the cylinder is too short you can extend the length by loosening the screw at the side of
the cylinder then pull the cylinder to the correct length.
2
English
3