Setup; Ac Power; Mounting; Setting Up The Board - Chauvet DJ Obey 40 Manual Usuario

3. S
ETUP

AC Power

Mounting

Setting Up The
Board

DMX Cabling

DMX Cabling
Diagram
Obey 40 User Manual Rev. 8
The Obey 40 has an auto-ranging external power supply, that can work with an input voltage range
of 100 to 240 VAC, 50/60 Hz. It runs on 9 VDC, 500 mA.
Before turning on the power, make sure the line voltage is within the range of accepted voltages as
listed on the label affixed to the product or as described in
The listed rating indicates average current draw under normal conditions.
· Always connect the board to a grounded circuit.
· Never connect the board to a rheostat or dimmer circuit.
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
The Obey 40 may be mounted in any position; make sure adequate ventilation is provided around
the product.
In order to use the controller it must be connected to the products with DMX cables and the products
must be addressed correctly. The sections below described DMX cabling and DMX addressing.
DMX cabling is required to get DMX values from the board to the products. Connect the DMX cable
from DMX Out of the board to DMX In of the first product in the rig.
Then connect another DMX cable from DMX Out of the first product in the rig to DMX In of the next
product.
Continue connecting until all the products are connected.
DMX DMX
In Out
st
1 Product
Technical Specifications
DMX DMX
In Out
nd
2 Product
in this document.
DMX DMX
In Out
rd
3 Product
Page 17 of 160
Additional
Products