Copying A Fader Assignment; Creating A Fader Reversal; Resetting The Board - Chauvet DJ Obey 40 Manual Usuario

Copying A Fader
Assignment
Creating A Fader
Reversal
Resetting the
Board
Page 20 of 160
Fader assignments can be copied from one fixture button to another.
To copy the fader customization from <FIXTURES 2> to <FIXTURES 11> do the following:
1. Press <Program> and <Tap Sync/Display> together to enter fader assignment customization.
2. Press and hold <FIXTURES 2>.
3. Continue holding <FIXTURES 2>, and press and hold <FIXTURES 11>.
4. Continue holding <FIXTURES 2> and <FIXTURES 11> and press and hold <Midi/Add>.
5. Continue holding <FIXTURES 11> and <MIDDI/Add>, but release <FIXTURES 2>.
6. Continue holding <Midi/Add>, but release the <FIXTURES 11>.
7. Release <Midi/Add>.
8. Press <Program> and <Tap Sync/Display> together to exit fader assignment customization.
Copying a custom fader assignment will not copy a reverse fader.
A fader reversal is when the order of values sent by a fader is reversed. Instead of sending the
highest value when the fader is up, a reversed fader sends the lowest value when the fader is up.
Fader reversals are a powerful tool, but they are not required.
The following instructions describe reversing a specific fader, but any fader, within any fixture button,
can be reversed.
To reverse <Channel 12> on <FIXTURES 9>, do the following:
1. Press <Program> and <Tap Sync/Display> together 2 times to enter fader reversal
customization.
2. Press the <FIXTURES 9>.
3. Move the <Speed Time> fader until 12 shows in the LCD display.
4. Move the <Fade Time> all the way up to activate fader reversal. The character to the right of 12
in the LCD display will change.
5. Press <Midi/Add> to save the setting.
6. Press <Program> and <Tap Sync/Display> together 2 times to exit fader reversal
customization.
Resetting the board clears out all customizations and programming, and returns the board to its
factory default settings. The board should be reset for new shows that require new customizations
and configurations. Resetting the Board can be used to clear out odd behaviors after many
customizations.
To reset the board, do the following:
1. Turn the board off.
2. Press and hold <Bank Up> and <Auto/Del> together.
3. While still pressing <Bank Up> and <Auto/Del>, turn the board on. The LCD display flashes to
indicate a successful operation.
· Resetting the board erases all scenes, chases, and customizations.
· Resetting the board can take up to 30 seconds.
Obey 40 User Manual Rev. 8