Operation - Craftsman 919.155190 Manual Del Usuario

All manuals and user guides at all-guides.com
Know Your Spray Gun
Machined Brass
External Mix Cap
Air Cap Horns
Hardened Steel
Fluid Tip
Release Lever
1- Quart
Siphon Feed
Material Cup
Machined Brass External Mix Cap -
The air and material are mixed after
leaving the nozzle to provide a
superior finish with thick and thin
material.
Hardened Steel Fluid Tip - for long
life.
Air Cap Horns - determines a
horizontal or vertical spray pattern.
Fluid Control Knob - controls the
fluid or density of fan spray.
Pattern Control Knob - controls the
size of the pattern from a large oblong
to small round pattern.
Air Valve Control Knob - fine tunes
the material spray with air.
1/4" NPT Air Inlet- allows the spray
gun to be connected to the air supply.
Release Lever - releases lid/gun
assembly from material cup.
Yoke - with built in wrench used to
easily remove gun from material cup
without tools.
D29783

OPERATION

Fluid Needle Adjustment Nut
Yoke
Air Valve
Control Knob
moval of any part of gun or attached
components, shut off compressor,
release pressure by depressing
trigger, and disconnect power
source. NEVER assume system
pressure is zero!
certain that all connections and fit-
tings are secure. Check hose and all
connections for a weak or worn
condition that could render system
unsafe. All replacement components
such as hose or fittings must have a
working pressure equal to or greater
than system pressure.
ATMOSPHERE, WORK ONLY IN
WELL VENTILATED AREAS.
8- ENG
Pattern Control
Knob
Fluid Control
Knob
1/4" NPT Air Inlet
Before
disassembly or re-
Prior to daily
operation, make
TO AVOID CREATING
AN EXPLOSIVE