Tools Required; Know Your Unit; Assembly Instructions - Cub Cadet BC2090 Manual Del Operador

APPLICATIONS
As a trimmer:
• Cutting grass and light weeds
• Edging
• Decorative trimming around trees, fences, etc.
As a brushcutter:
• Cutting weeds and light brush of up to 1/2 inch in diameter
Other optional accessories may be used with this unit. Refer to Operating
the EZ-Link System for a list of add-ons.

TOOLS REQUIRED:

• Large Phillips screwdriver
• Flat blade screwdriver
• 13 mm wrench
• Locking rod
Brush Blade
Gear Housing
Cutting Attachment
On some units, the J-handle may be pre-installed. In this case, loosen the
screws and go to step 5.
INSTALL AND ADJUST THE J-HANDLE
1. Place the J-handle between the top and middle clamp pieces (Fig. 1).
(4) Screws
Bottom Clamp
Nuts
2. While holding the three pieces together, install the four (4) screws
through the top clamp and into middle clamp.
NOTE: The holes in the top and middle clamp will line up only when
assembled correctly.

KNOW YOUR UNIT

Blade Shield /
Shield Mount
EZ-Link™
Shaft Housing
Cutting Attachment Shield

ASSEMBLY INSTRUCTIONS

J-Handle
Top Clamp
Middle Clamp
Fig. 1
Throttle Lock-Out
On/Off Stop Control
Shoulder Strap Clip
J-Handle
Engine Stand
Line Cutting Blade
3. Place the clamps and the J-handle over
the shaft housing and onto the bottom
clamp.
4. Hold each hex nut in the bottom clamp
recess with a finger. Start screws with a
large Phillips screwdriver. Do not tighten
until you make the handle adjustment.
5. Slide the J-handle in or out until the
arrow/white line on the decal touches
the clamp assembly (Fig. 2). You must
first loosen the screws if the handle is
pre-installed.
6. While holding the unit in the operating
position (Fig. 3), position the J-handle to
the location that provides you the best
grip.
7. Tighten the clamp screws evenly, until
the J-handle is secure.
Fuel Cap
Starter Rope Grip
Shaft Grip
Throttle
Control
Blue Choke Lever
Primer Bulb
Spark Plug
Air Filter /
Muffler Cover
Muffler
Decal
Fig. 2
Fig. 3
5