Becken BDW1965N IX Manual De Instalación página 13

The cable should not be bent or compressed.
If the power supply cable is damaged, it must be replaced by the
manufacturer or its Customer Support Service in order to prevent all
potential hazards (contact the Customer Support Service).
The company shall not be held responsible for any incidents that
occur if these regulations are not observed.
Advice regarding the first washing programme
After the appliance has been installed, immediately before running
the first washing programme, completely fill the salt dispenser and
add approximately 2 Kg of salt. The water may overflow: this is normal
and is not a cause for concern. It is also normal that the LOW SALT
indicator light continues to flash for a few cycles after the salt has been
loaded.
Positioning the Appliance
Position the appliance in the desired location. The back should rest
against the wall behind it, and the sides, along the adjacent cabinets
or wall. The dishwasher is equipped with water supply and drain
hoses that can be positioned to the right or the left to facilitate proper
installation.
Levelling the Appliance
Once the appliance is positioned, adjust the feet (screwing them in or
out) to adjust the height of the dishwasher, making it level. In any case,
the appliance should not be inclined more than 2°.
Note: the maximum adjustment height of the feet is 20 mm.
How to drain excess water from hoses
If the sink is 1000 mm higher from the floor, the excess water in the
hoses cannot be drained directly into the sink. It will be necessary to
drain the excess water from the hoses into a bowl or into a suitable
container that is held outside and lower than the sink.
Dishwasher | Lavavajillas | Máquina de Lavar Loiça
EN
13