Guide Bar Maintenance; Chain Maintenance Table - SNOWJOE SUNJOE SWJ807E Manual Del Operador

Sharpening is necessary when:
• The sawdust looks like dust;
• Cutting becomes more difficult;
• The cut is not straight;
• Vibrations increase.
An authorized service center will sharpen the chain using the
right tools to ensure minimum removal of material and even
sharpness on all the cutting edges.
If you sharpen the chain yourself, use special round-section
files with the right diameter depending on the type of chain
(see "Chain Maintenance Table"). You need a certain amount of
skill and experience to avoid damaging the cutting edges.
Sharpen the chain as follows (Fig. 32):
• Secure the bar firmly, with the chain mounted, in a
suitable vise.
• Tighten the chain if it is loose.
• Mount the file in the guide and then insert it in the tooth at
a constant angle from the cutting edge.
• Sharpen in a forward motion a few times and repeat this
on all the cutting edges facing the same way (right or left).
• To move the chain forward, use a screwdriver.
• Turn the bar over in the vise and repeat on all the other
cutting edges.
• Check that the depth limiter tooth does not stick out
farther than the inspection tool and file any projecting
parts with a flat file, rounding off the edges (Fig. 30).
• After sharpening, remove all traces of filing and dust
and lubricate the chain in an oil bath. Replace the chain
whenever:
– The length of the cutting edges decreases to 5 mm
or less;
– There is too much play between the links and the rivets.

Chain Maintenance Table

Drive Links
40
Chain Pitch
inches mm
3/8
9.5
17
Fig. 32
Cutting edge

Guide Bar Maintenance

When the guide bar shows signs of wear, turn it over on the
saw to distribute the wear for maximum bar life. Feathering or
burring of the bar rails is a normal process of bar wear. You
should smooth such faults with a file as soon as they occur.
Replace a bar with any of the following faults:
• wear inside the bar rails permitting the chain to
lay over sideways
• bent guide bar
• cracked or broken rails
• spread rails
Turn the saw over, check the underside of the guide bar, and
make sure that the lubrication holes and chain groove are free
from impurities.
You can purchase replacement parts for your Sun Joe
SWJ807E 2-in-1 electric pole + chain saw by ordering online at
sunjoe.com or, to order by phone, contact Snow Joe
®
Sun Joe customer service at 1-866-SNOWJOE
(1-866-766-9563).
Chain Gauge
mm
inches
1.3
0.050
Inspection tool
Depth
limiter
tooth
Depth limiter tooth
®
® +
File Diameter
inches mm
5/32
4