SNOWJOE SUNJOE SWJ807E Manual Del Operador página 8

Fig. 3
Chain
3. Remove the old chain from the bar.
4. Lay out the new saw chain in a loop and straighten
any kinks. THE SHARP SIDE OF THE TEETH MUST
FACE AWAY FROM YOU IN THE DIRECTION OF THE
CHAIN ROTATION INDICATED ON THE GUIDE BAR
turn the loop over (Fig. 4).
Fig. 4
Sharp cutting edge
Chain drive link
5. Starting at the tip, mount the chain drive links into the
bar groove, leaving a loop at the back of the bar. The
chain will loosely fit until it is placed on the sprocket
(Figs. 5 & 6).
NOTE: Make certain of the direction of the chain
backwards, the saw will vibrate abnormally and will not
cut.
Fig. 5
Cutting bar
R
. If the teeth face backwards,
Chain rotation
.If the chain is mounted
Fig. 6
Loop
6. Hold the chain in position on the bar and place the loop
around the sprocket. Fit the bar flush against the mounting
surface so that the bar studs are in the long slot of the bar
and the adjusting pin is in the chain tension pin hole
(Fig. 7).
Fig. 7
Sprocket
7. Adjust the chain tension as needed by adjusting the
chain tensioner screw with the supplied flat-tip blade
screwdriver. Make sure to align the chain tensioner screw
with the pin hole (Fig. 8).
Fig. 8
Chain tensioner
Blade screwdriver
8. Replace the chain/sprocket end cover. Tighten the end
cover nut, but leave the bar free to move for tension
adjustment.
8
Chain tension pin hole
(with adjusting pin)
R
Bar studs