BizLine 780 313 Manual De Instrucciones página 5

Clamp size
Diode Test
Continuity Check Threshold
Low Battery Indication
Overrange Indication
Measurements Rate
Input Impedance
Display
AC Current
AC Voltage bandwidth
Operating Temperature
Storage Temperature
Relative Humidity
Altitude
Over voltage
Battery
Auto OFF
Dimensions/Weight
Safety
Operation
NOTES : Read and understand all warning and precaution statements listed in the safety section
of this operation manual prior to using this meter. Set the function select switch to the
OFF position when the meter is not in use.
DC/AC Current Measurements
WARNING: Ensure that the test leads are disconnected from the meter before
making current clamp measurements.
1. Set the Function switch to the 1000A or 400A or
40A range. If the range of the measured is not known, select the higher
range first then move to the lower range if necessary.
2. Select AC or DC with the MODE button.
3. Press the trigger to open jaw. Fully enclose one conductor
to be measured.
4. The clamp meter LCD will display the reading.
DC/AC Voltage Measurements
1. Insert the black test lead into the negative COM terminal and the red
test lead into the positive V terminal.
2. Set the function switch to the V position.
3. Select AC or DC with the MODE button.
4. Connect the test leads in parallel to the circuit under test.
5. Read the voltage measurement on the LCD display
Exe_Notice_BIZ 780313.indd 5
Opening 1.2» (30mm) approx
Test current of 0.3mA typical; Open circuit voltage 1.5V DC
typical.
<100 Ω; Test current < 1mA
" " is displayed
"OL" is displayed
2 per second, nominal
7.8M Ω (VDC and VAC)
4000 counts LCD
50/60Hz (AAC)
50/60Hz (VAC)
14 to 122oF (-10 to 50oC)
-14 to 140oF (-30 to 60oC)
90%(0oC to 30oC); 75%(30oC to 40oC); 45%(40oC to 50oC)
Operating: 3000m; Storage 10,000m
Category III 600V
One "9V" Battery
approx. 35 minutes
229x80x49mm/303g
For indoor use and in accordance with Overvoltage
Category II, Pollution Degree 2. Category II includes local
level, appliance, portable equipment, etc., with transient
overvoltages less than Overvoltage Cat. III
.
No Yes
15/05/2019 17:35
EN
5